The XP-CPRO2L lift access controller can be used to control the access to the levels in the building. It uses the Mio-R16 to control the access to each of the floor. Each card holder is assigned with a floor zone setting which contains the information of how he/she can access to each of the level. You may configure that the card holder only able the access to a certain levels but denied entry in to others. The XP-CPRO2L lift access control system can be used together with other MicroEngine's door access equipments under the management of a single software system – xPortal2005 or xPortalNet. In this way, the accessibility of the card holder in to each of the area including the control inside the lift can be managed from a single point.   AccessPortal XP-CPRO2L Lift Access Control System
Autonomy	Distributed data and preocessing
Downlink	2 wire RS485
No of CDP	2
No of Floor	64/COP
Battery backed real time clock	Yes
Onboard rechargeable battery	Yes
Card Number	6 digits
Continuous reads when door left open	Yes
Operating modes	Card only
Time Zone	255
Time Set	255 each with 3 intervals
Holidays	30
Onboard Watchdog Circuit	Yes
Auto lock release by time zone	Yes
Cardholders	10,000
Events	20,000
RAM memory	At least 128KBtye
RAM protected by On board battery	Yes
Firmware EPROM/flash memory	At least 128KBtye
Addressing via switch	Yes
Addressing via switch	Yes
Communication ports	RS485
Polarity protection for power connector	Yes
Power	12VDC
Relay interface unit	MTR16
Reader Interface unit	MK800

• Standalone Access Control System
• Single Door + Multi Functions Access Control System
• Advance Multi-Door Access Control System
• FingerPrint
• Car Park System